Guralp-systems CMG-3ESPCD Bedienungsanleitung Seite 97
- Seite / 98
- Inhaltsverzeichnis
- LESEZEICHEN
- CMG-3ESPCD 1
- Table of Contents 2
- 1 Preliminary Notes 5
- 2 Introduction 6
- 2.1 Sensor response 7
- 3 Installing the 3ESPCD 8
- 3.1.4 Connections 9
- 3.1.5 FireWire 9
- 3.2 Installation notes 10
- 3.3 Installing in vaults 11
- 3.4 Installing in pits 14
- 3.6 Rapid installation 17
- 3.6.1 Deployment 18
- 3.6.2 Recovery 21
- 3.7 Installing in post-holes 22
- 3.8 Using the 3ESPCD 23
- 3.8.2 Reading digitiser disks 24
- 4 Calibrating the 3ESPCD 28
- 4.2 Calibration methods 32
- 4.3 Calibration with Scream! 33
- 4.4 The coil constant 37
- 5 Using Scream! 39
- 5.1.1 System ID 40
- 5.1.2 Output control 41
- 5.1.3 Triggering 44
- 5.1.3.1 STA/LTA 45
- 5.1.3.2 Level 50
- 5.1.3.3 External triggering 50
- 5.1.4 Mux Channels 51
- 5.1.5 Ports 51
- 5.2 Controlling digitisers 53
- 5.2.2 Triggering 54
- 5.2.3 Calibration 54
- 5.2.4 Mass Control 54
- 5.2.5 Data flow 55
- 5.2.5.1 DIRECT 56
- 5.2.5.2 FILING 56
- 5.2.5.3 Heartbeat messages 56
- 5.2.5.5 ADAPTIVE 58
- 5.2.5.6 DUAL 58
- 5.2.5.7 RE-USE / RECYCLE 59
- 5.2.5.8 WRITE-ONCE 59
- 6 Command line interface 60
- 6.2 General configuration 61
- 6.2.4 BAUD 62
- 6.2.5 AZIMUTH 62
- 6.3 Output configuration 63
- 6.3.2 CONTINUOUS 64
- 6.3.3 SET-TAPS 64
- 6.4 Triggering 65
- 6.4.4 LTA 66
- 6.4.5 RATIOS 66
- 6.4.6 PRE-TRIG 66
- 6.4.7 POST-TRIG 66
- 6.5 Calibration 67
- 6.5.2 SQUAREWAVE 68
- 6.5.3 RANDOMCAL 68
- 6.5.4 MINUTE 69
- 6.6 Actions 70
- 6.6.4 RE-BOOT 71
- 6.7.1 SHOW-FLASH 71
- 6.7.2 DIRECT 72
- 6.7.3 FILING 72
- 6.7.4 ADAPTIVE 72
- 6.7.5 FIFO 72
- 6.7.6 DOWNLOAD 73
- 6.7.7 ALL-FLASH 73
- 6.7.8 ALL-DATA 73
- 6.7.9 STREAM 73
- 6.7.10 STATUS-ONLY 74
- 6.7.11 S/S 74
- 6.7.12 ALL-TIMES 74
- 6.7.13 FROM-TIME 74
- 6.7.14 TO-TIME 74
- 6.7.15 GO 75
- 6.7.16 END-DOWNLOAD 75
- 6.7.17 DISKMENU 75
- 6.7.18 MBTRANSFER 76
- 6.7.19 ERASEFILE 76
- 7 Inside the 3ESPCD 77
- 7.1.2.1 LOCK 78
- 7.1.2.2 UNLOCK 79
- 7.1.2.3 CENTRE 80
- 7.1.3 The feedback system 81
- 7.1.3.1 Hybrid feedback 82
- 7.1.3.3 Comparisons 84
- 7.2 Inside the DM24 85
- 7.2.2.2 from the command line 87
- 7.2.3.2 Loading new DSP code 89
- 8.1 GPS port 90
- 8.2 DATA OUT port 92
- 8.3 FIREWIRE port 93
- 11 Revision History 98
Verwandte Produkte und Handbücher für Werkzeug Guralp-systems CMG-3ESPCD
(108 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.067 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern