Guralp-systems CMG-3ESPCD Installation Bedienungsanleitung Seite 1
Stöbern Sie online oder laden Sie Bedienungsanleitung nach Werkzeug Guralp-systems CMG-3ESPCD Installation herunter. Guralp Systems CMG-3ESPCD Installation User Manual Benutzerhandbuch
- Seite / 2
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
CMG-3ESPCD
Digital sensor
Installation
Check you have all components and cables.
- CMG-3ESPCD digital weak motion seismometer
- GPS receiver
- Brown GPS—sensor cable
- Blue/grey combined sensor—PC and power cables
- Sensor calibration data booklet
You will need a Windows or Linux PC with an RS232 port
and a 12–24 V DC power supply.
Choose suitable sites to install the sensor and GPS.
The sensor should be mounted
- at, or ideally below, ground level
- in contact with bedrock, if possible
- otherwise, on a hard granite or concrete pier
- in an environment with constant temperature
- shielded from air currents
- away from electrical cables and appliances
The GPS should be placed
- within 15 m of the sensor
- in a place with a wide view of the sky and a low
horizon.
Connect the various parts together.
- Connect the brown cable attached to the GPS
to the GPS connector on the sensor.
- The blue cable ends at a 9-pin RS232 socket.
Connect this socket to your PC’s serial connector.
- The attached grey cable ends in
red and black wires. Connect the black wire to the
negative (–) terminal of the power supply,
and the red wire to the positive (+) terminal.
- The blue and grey cables are joined together at
a 10-pin mil-spec socket. Attach this to the DATA
connector on the sensor. Do this step last.
To test the installation, follow the steps overleaf.
1
2
3
RS232
GPS
Power
supply
+
–
PC
CMG-
3ESPCD
1
2
Inhaltsverzeichnis
Seite 1 - CMG-3ESPCD
CMG-3ESPCDDigital sensor InstallationCheck you have all components and cables.- CMG-3ESPCD digital weak motion seismometer- GPS receiver- Brown GPS—se
Seite 2 - MSH-C3E-0002-B : Page 2 of 2
Testing457Switch on the power supply and measure the current through the instrument. With the GPS connected and running, the current should be around
Verwandte Produkte und Handbücher für Werkzeug Guralp-systems CMG-3ESPCD Installation
Werkzeug Guralp-systems CMG-6TD Bedienungsanleitung
(108 Seiten)
(108 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern